Introduction

For industrial purpose the power is to be delivered for larger distance hence AC power supply is required to drive the motors. The rectifier in a VFD is used to convert incoming ac power into direct current (dc) power. There are 3 pair of rectifier combination is used for converting 3 phase AC into DC Normally 6,12 or 18 diodes will be used to serve this purpose. Rectifiers can be built using diodes, silicon controlled rectifiers (SCR), or transistors to rectify power. After the power flows through the rectifiers it is stored on a dc bus. The dc bus contains capacitors to accept power from the rectifier and stores it and finally delivers that power through the inverter section.

VFDS LLC is a leader among variable frequency drive suppliers. Our company concentrates on inverter design and VFD manufacture. VFDS LLC is china VFDS Company located in Shenzhen. Our main focus is creating the highest quality products. The main products single phase to three phase VFD, three Phases to three Phase VFD and so on.

I recently was doing some energy savings projections that involved looking at what would happen if I added a Variable Frequency Drive (VFD) to a pump serving a hot water system. In the course of doing that, I got to wondering if there had been improvements in VFD efficiency that I should take into account since the last time I researched drive efficiency.

Variable frequency drive - VFDs can be used to control the speed of a machine. There can be significant energy reduction if the machine is slowed down when it does not need to operate at full speed. For example, pumps operated so that they run at a speed dependent on the flow requirements will reduce the cavitation losses in the pump. If the pump is required to run at constant full speed, the addition of a VFD will actually waste another 5% of energy.

Lastest Products

Single phase to three phase VFD

1HP VFD

2HP VFD