Rubber & Products
Description
Description
addition molding silicone is generally named two-components silicone rubber, Part A is a flowable liquid, part B is the curing agent. It features an exceptional fluidity and good operability. The mixing ratio is 1:1,mainly be suitable for making FDA molds application.
Applications
HY- E642# addition molding silicone could be mainly used for making concrete stones, precision molds, PU molds, for life casting, fabric finishing, seal for electronic components and solar circuit board, trademark decoration. etc.
OPERRATING INSTRUCTION of HY-E642# molding silicone:
1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)
2. Enclose the product (the original model) with four plastic plates or wooden plates.
3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.
4. Pour the mixture with correct mixing ratio into the model frame.
After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .
For getting further information about additional silicone rubber, PLS contact with Miss Sara
TEL: +86-755-89948013
Mobile: +86-15818782621
Email: saratian.2013(at)yahoo(dot)cn or hysf(at)szrl(dot)net
Website : www(dot)szrl(dot)net
Read More
Hong Ye Jie Technology Co.,Ltd
silicon,silicone rubber,molding silicone rubber,RTV silicone rubber,additional silicone rubber,silicone products,Rubber products ,injection silicone rubber , LSR silicone rubber
Address: Building A, No.3, Hongling First Road, Liulian Shibi, Pingdi Street, Longgang district, Shenzhen, Guangdong province, China ,
Shenzhen, Guangdong province
China, 518117
Tel: 86-755-89943013
Fax: 86-755-89943030
