Instruments & Meters
Description
RWG-4K16 IEC61000-4-12 Ring wave Generator
Introduction:
Ring wave generator is completely meet the requirements of IEC61000-4-12, GB/T17626.12 and ANSIC62.41/45.Ring wave generator is used for the simulating electrical network, the power supply of the reactive load the control line switch, as well as sensing the ring wave of the low voltage cables terminal equipment caused by the disconnection of the power circuit, fault and insulation breakdown or lightning stroke. It is widely used in electronic equipment.
Parameters:
Voltage Oscillation frequency (open): 100kHz±10%
Output voltage(open): （250V~4000V）±10%
Frontier(open circuit voltage,T1,10%~90%): 0.5μs±30%
Frontier(short circuit voltage,T2,10%~90%): ≤0.9μs
Short circuit current at 3500V(PK1): 292A±10% @12Ω
117A±10%@30Ω
Interval: 1s~99s
Impulse times: 1~9999times
Output mode: Positive, negative, positive/negative auto
Output Impedance: 12Ω，30Ω
Phrase: asynchronous, synchronous
Coupling and decoupling network(CDN): 16A single Phrase or 20A 2phrases/5wires
Read More
Pego Group (HK) Company Limited
spring hammer, surge generator, electrostatic discharge generator, e14 lamp cap gauges, etc.
Address: No.233, Yangshan Road, Yuanzhou Disctrict, Yichun, Jiangxi, 336000, China,
Yichun, Jiangxi
China, 336000
Tel: 86-795-3560528
Fax: 4008266163-29929
